Bike Cable Lid Support - Woodworking Tip #23

For a cyclist a broken brake cable just means longer stopping distance. For a pilot a broken elevator cable means landing, look mom, “no hands,” using flaps, power and trim for pitch control. For my lady a broken jewelry box lid support cable meant holding the lid with the left hand as the right hand sought the day's adornments. Really, not bad: after 29,251 cycles this bike cable lid support broke, though not the cable itself. The cable pulled out of its crimped ring connector on the lid. It was easily replaced with a fresh piece of bicycle brake cable and a new ring wire connector.

Using Soss hinges, as I did, on this walnut and cherry jewelry box with a full-width earring tray and music movement, the hinge itself provided no lid support. Furthermore, the full tray under the lid allowed no space for a scissors lid stay.  A light cord or chain tends to either get kinked or ends up draping outside of the box.  The solution was found in of all places my cycling ditty box. Taking a brake cable I cut the nipple end down to about 6 inches, threaded it through a diagonal hole in the support dowel for the earring tray and crimped the end to an uninsulated ring wire connector. The ring connector was then screwed to the underside of the lid. The clearance of only 1/16” between the tray and side of the jewelry box still allowed the cable to slide by, though during this recent repair I relieved the side of the tray slightly to permit even easier movement.  If you use a rail instead of dowels to support the tray the diagonal cable hole would go through it.

The barrel nipple at the end of the cable hits the bottom of the box when the lid is closed and neatly slides forward along the bottom of the box. The real beauty of this system is that the bike cable is rigid enough to have no tendency to fold or kink. Surprisingly, little pressure must be exerted on the felt as it appears completely unmarred even after 29,251 cycles.  There you have it:  a synthesis of two of my loves, cycling and woodworking, for my love.

To view all previous Woodworking Tips just type "woodworking tip" into the search box at the top of the blog's first page.  Unique woodenwares made from saved wood are available at our eco-friendly Etsy shop:  FlyingCircusStudios

New Needlepoint Collaborator

My wife's lifetime role of educator has taken a new turn with her granddaughter Amelia as student in needlepoint.  Much love and patience were injected into this lovely still life, though ofttimes the progress of the piece suffered its own still life.  Nonetheless, our six-year-old Amelia, turning seven just at completion, persevered and accomplished a fine first needlepoint, a gift to her parents.   Readers of this blog might realize I fabricated the accompanying frame out of cherry wood as I have done with my wife Sara's needlepoints, ten framed pieces so far.  Amelia also helped out some with the framing, bringing out the rich cherry wood color with applications of Watco oil.

A hearty congratulations to the artist and also to her dad Josh whose birthday is today!